PIONEER VSX49TXI
Instrukcja Serwisowa

1

2

3

4

A

Receiver SUB Screen

1
Receiver
TONE BASS/ TREBLE EFFECT/ CH SEL. LOUDNESS TAPE 2 MONITOR INPUT ATT. SIGNAL SELECT MAIN SUB

-

B

2 3 4

DISPLAY DIMMER STATUS SYSTEM SETUP

VIDEO SELECT SPEAKER A/B

0 9

567
C

8

1 Receiver SUB button
Press this button to select the SUB receiver screen (above) when the remote control is on the main receiver screen.

9 SIGNAL SELECT button
Press SIGNAL SELECT repeatedly to select one of the following (Depends on settings in INPUT ASSIGN, available inputs will change.): ANALOG : To select an analog signal. : To select an i.LINK signal. DIGITAL : To select an optical or coaxial digital signal. 2 RF : To select an 2 RF signal. AUTO : This is the default. The receiver selects a signal based on availability, in the following order of priority: , 2 RF DIGITAL, ANALOG. ,

2 DISPLAY DIMMER button
Use to adjust the brightness of the receiver's display.

3 STATUS button
Use to display the present mode of the receiver and other selected settings.
D

4 SYSTEM SETUP button
Use for all system setups, including the speaker and sound systems. For more information see �Setting up for Surround Sound�.

0 INPUT ATT. button
Use to lower the input level of an analog signal that is too powerful, thus causing the receiver to distort. In this case the overload (OVER) indicator will be flashing furiously.

5 VIDEO SELECT button
Use to toggle between the different video input possibilities.

- TONE control/EFFECT CH SEL. buttons
TONE button This button has two functions. Firstly, it switches between TONE on and TONE BYPASS, which bypasses the tone circuitry. Secondly, you need to press the button before using the BASS & TREBLE (+/�) buttons. EFFECT/CH SEL. button Switches the tone adjust controls between the front, center, surround and surround back speakers. While in Advanced mode, you can also adjust the effect level or SOUND DELAY in 5 ms steps from 0 to 200 ms to match sound with slower video displays. You can then use the + and � buttons to adjust the sound.

6 SPEAKER A/B button
Use to select the speaker system. A is the primary setting. The button cycles through the speaker systems as follows: A]B]A&B]off. Different conditions apply when bi-amping the speakers.

E

7 LOUDNESS button
Switches the LOUDNESS mode on or off (for all modes except THX).

8 TAPE 2 MONITOR button
Selects the tape deck (or MD recorder, etc.) connected to the TAPE 2 MONITOR inputs/ outputs. Allows monitoring of a recording as it's being made.

F

174
1 2

VSX-49TXi
3 4