...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 57 (kliknij aby zobaczyć)
VSX-709RDS, VSX-609RDS
8. PANEL FACILITIES AND SPECIFICATIONS
8.1 PANEL FACILITIES
Front Panel
This illustration shows the VSX-709RDS model.
1 � OFF/ _ ON (Main power) button
If the button is OFF (�), the power of the receiver is shut off and the STANDBY/ON button (3) on the receiver or the remote control do not function. Pressing the button again will turn the receiver ON (_) and the receiver enters the standby mode. In the standby mode, you can turn on the receiver using the STANDBY/ON button (3) on the receiver or the remote control.
8 CHARACTER/SEARCH button
Use to search for different program types in RDS mode. It is also used to input station names.
9 DIRECT button
Use to switch Direct playback on or off. This mode bypasses the tone controls and channel levels for the most accurate reproduction of a program source.
2 STANDBY indicator
Lights when the receiver is in standby mode (note that the receiver consumes a small amount of power (1 W) in standby mode).
0 BASS (+/�) buttons
Use to increase/decrease bass (within a range of 6 dB in 2 dB steps). � 6 dB to
- Display = TREBLE (+/�) buttons
Use to increase/decrease treble (within a range of 6 dB in 2 dB steps). � 6 dB to
3
STANDBY/ON button
Switches the receiver between on and standby (note that the receiver consumes a small amount of power (1 W) in standby mode).
4 TUNING SELECT button
Switches between station memory and frequency select modes.
~ MIDNIGHT button
Use when listening to movie soundtracks at low volume. This feature will enable you to hear quiet sounds and not get jolted by loud or sudden sound effects.
STATION (+/�) buttons
Selects station memories when using the tuner.
! Remote sensor (�)
Receives the signals from the remote control.
FREQUENCY (+/�) buttons
Selects the frequency when using the tuner.
@ DSP MODE button
Use to switch between the various DSP modes available (HALL1, HALL 2, JAZZ, DANCE, THEATER1, THEATER 2) and DSP off. Use to create different surround sound effects from any stereo source.
5 CLASS button
Switches between the three banks (classes) of station memories.
6 MEMORY button
Press to memorize a station for recall using the STATION (+/�) buttons.
# 2 /DTS button
Use to switch between the various Dolby/DTS surround modes.
7 RF ATT button
Use to lower the input level of a radio signal that is too powerful or contain interference thus causing the receiver to distort
$ SIGNAL SELECT button
Use to select between an analog or digital signal.
% MASTER VOLUME
Use to set the overall listening volume.
