Manual speaker setup
This receiver allows you to make detailed settings to optimize the surround sound performance. You only need to make these settings once (unless you change the placement of your current speaker system or add new speakers.). These settings are designed to fine-tune your system, but if you�re satisfied with the settings made in Automatically setting up for surround sound (MCACC) on page 12, it isn�t necessary to make all of these settings.
2 Use / (cursor left/right) to choose the speaker(s) that you want to set then select a speaker size. Use / (cursor up/down) to select the size (and number) of each of the following speakers: � Front (F) � Select LARGE if your front
speakers reproduce bass frequencies effectively, or if you didn�t connect a subwoofer. Select SMALL to send the bass frequencies to the subwoofer.1 � Center (C) � Select LARGE if your center speaker reproduces bass frequencies effectively, or select SMALL to send bass frequencies to the other speakers or subwoofer. If you didn�t connect a center speaker, choose NO (the center channel is sent to the front speakers). � Surround (S) � Select LARGE if your surround speakers reproduce bass frequencies effectively. Select SMALL to send bass frequencies to the other speakers or subwoofer. If you didn�t connect surround speakers choose NO (the sound of the surround channels is sent to the front speakers or a subwoofer). � Surround Back (SB) � Select the number and size of surround back speakers you have. Select LARGE if your surround back speakers reproduce bass frequencies effectively. Select SMALL to send bass frequencies to the other speakers or subwoofer. If you didn�t connect surround back speakers choose NO.2 � Subwoofer (SW) � LFE signals and bass frequencies of channels set to SMALL are output from the subwoofer when YES is selected (see notes below). Choose the PLUS setting if you want the subwoofer to
1 Select �SP SETUP� from the System Setup menu then press ENTER. See Making receiver settings from the System Setup menu above. 2 Use / (cursor left/right) to select the setting you want to adjust then press ENTER. If you are doing this for the first time, you may want to adjust these settings in order:
� SP SET � Specify the size and number of speakers you�ve connected (see Speaker setting below). � X.OVER� Specify which frequencies will be sent to the subwoofer (see Crossover network on page 49). � CH LEVEL � Adjust the overall balance of your speaker system (see Channel level on page 49). � SP DISTN. � Specify the distance of your speakers from the listening position (see Speaker Distance on page 50).
Speaker setting
Use this setting to specify your speaker configuration (size, number of speakers). It is a good idea to make sure that the settings made in Automatically setting up for surround sound (MCACC) on page 12 are correct.
Note
1 If you select SMALL for the front speakers the subwoofer will automatically be fixed to YES. Also, the center, surround, and surround back speakers can�t be set to LARGE if the front speakers are set to SMALL. In this case, all bass frequencies are sent to the subwoofer.
