PIONEER VSX-917V-K/SPWXJ
Instrukcja Obsługi

The System Setup menu

07

� SB � Select the number of surround back speakers you have (one, two or none). Select LARGE if your surround back speakers reproduce bass frequencies effectively. Select SMALL to send bass frequencies to the other speakers or subwoofer. If you didn�t connect surround back speakers choose NO.1 � SUB W. � LFE signals and bass frequencies of channels set to SMALL are output from the subwoofer when YES is selected (see notes below). Choose the PLUS setting if you want the subwoofer to output bass sound continuously or you want deeper bass (the bass frequencies that would normally come out the front and center speakers are also routed to the subwoofer). If you did not connect a subwoofer choose NO (the bass frequencies are output from other speakers). 3 When you�re finished, press RETURN. You return to the Manual SP Setup menu. Tip � If you have a subwoofer and like lots of bass, it may seem logical to select LARGE for your front speakers and PLUS for the subwoofer. This may not, however, yield the best bass results. Depending on the speaker placement of your room you may actually experience a decrease in the amount of bass due to low frequency cancellations. In this case, try changing the position or direction of speakers. If you can�t get good results, listen to the bass response with it set to PLUS and YES or the front speakers set to LARGE and SMALL alternatively and let your ears judge which
Note

sounds best. If you�re having problems, the easiest option is to route all the bass sounds to the subwoofer by selecting SMALL for the front speakers.

Crossover Network
� Default setting: 100Hz This setting decides the cutoff between bass sounds playing back from the speakers selected as LARGE, or the subwoofer, and bass sounds playing back from those selected as SMALL. It also decides where the cutoff will be for bass sounds in the LFE channel.2 1 Select �Crossover Network� from the Manual SP Setup menu.
4.Manual SP Setup a.Speaker Setting b.Crossover Network c.Channel Level d.Speaker Distance 4b.Crossover Network Frequency 80Hz

:Return

:Finish

2 Choose the frequency cutoff point. Frequencies below the cutoff point will be sent to the subwoofer (or LARGE speakers). 3 When you�re finished, press RETURN. You return to the Manual SP Setup menu.

Channel Level
Using the channel level settings, you can adjust the overall balance of your speaker system, an important factor when setting up a home theater system.

English Deutsch Français Italiano Nederlands Español
45
En

1 � If the surround speakers are set to NO, the surround back speakers will automatically be set to NO. � If you selected Second Zone or Front Bi-Amp (in Surround back speaker setting on page 38) you can�t adjust the surround back settings. � If you select one surround back speaker only, make sure that speaker is hooked up to the left surround back terminal. 2 For more on selecting the speaker sizes, see Speaker Setting above.