Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 27 (kliknij aby zobaczyć)
Fine Tuning Your Surround Sound
Follow steps 1-3 on page 25 (if necessary). Press % or � to specify the crossover frequency for your small speakers (100 Hz, 150 Hz or 200 Hz). 100Hz 150Hz
FRONT speakers distance setting mode
Set the distance from the FRONT speakers to the listening position.
Follow steps 1-3 on page 25 (if necessary). Press % or � to set the distance of the FRONT speakers from the main listening position (within a range from 0.3 m to 9.0 m).
Press # to advance to the next receiver setting mode, or press @ to return to a previous receiver setting mode.
200Hz
100 Hz Sends bass frequencies below 100 Hz to the subwoofer (or �Large� speakers). 150 Hz Sends bass frequencies below 150 Hz to the subwoofer (or �Large� speakers). 200 Hz Sends bass frequencies below 200 Hz to the subwoofer (or �Large� speakers). Press # to advance to the next receiver setting mode, or press @ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting mode.
MEMO: � The default setting is 1.8 m. � One step equals about 0.3 m. � If you do the ROOM SETUP settings after the settings here, those will take precedence.
Press ENTER if you want to exit the setting mode.
MEMO: � The default setting is �200 Hz�. � If there are no �Small� speakers � in SPEAKERS setting mode, crossover frequency cannot be set (��� appears in the display).
CENTER speaker distance setting mode
Set the distance from the CENTER speakers to the listening position.
Follow steps 1-3 on page 25 (if necessary). Press % or � to set the distance of the CENTER speaker from the main listening position (within a range from 0.3 m to 9.0 m).
Press # to advance to the next receiver setting mode, or press @ to return to a previous receiver setting mode.
LFE attenuator setting mode
Dolby Digital and DTS audio sources include ultra-low bass tones. Set the LFE attenuator as needed to prevent the ultra-low bass tones from distorting the sound from all the active speakers.
Press ENTER if you want to exit the setting mode.
English
MEMO: � The default setting is 1.5 m. � One step equals about 0.3 m. � When �C _� is selected in SPEAKERS setting mode, the Center distance cannot be set. � If you do the ROOM SETUP settings after making the settings here, those will take precedence.
Follow steps 1-3 on page 25 (if necessary). Press % or � to set the attenuation level:
0 dB 10 dB LFE OFF
0 dB : no attenuation 10 dB : LFE volume is reduced LFE OFF : LFE channel is off.
Press # to advance to the next receiver setting mode, or press @ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting mode.
MEMO: � The default setting is �0 dB�.
