STANDBY/ON button
Switches the receiver between on and standby.
0 DOLBY PRO LOGIC button (see page 20)
Use to switch between the various Pro Logic modes (PRO LOGIC, PRO LOGIC THEATER1, PRO LOGIC THEATER2) and Pro Logic off.
2 STANDBY indicator
Lights when the receiver is in standby mode (note that the receiver consumes a small amount of power (1W) in standby mode).
- MASTER VOLUME
Use to set the overall listening volume.
3 STATION (+/�), FREQUENCY (+/�), TUNING SELECT buttons (see pages 23�25)
STATION (+/�) Selects station memories when using the tuner. FREQUENCY (+/�) Selects the frequency when using the tuner. TUNING SELECT Switches between station memory and frequency select modes.
= PHONES jack
Use to connect headphones but this does not switch the speakers off.
~ SPEAKER button
Use to switch the speaker system on or off.
! FL DIMMER button
Use this button to make the fluorescent display (FL) dimmer or brighter. There are three brightness settings as well as an off setting.
4 CLASS button (see page 25)
Switches between the three banks (classes) of station memories.
@ BASS (+/�) buttons
Use to increase/decrease bass (within a range of �6dB to 6dB in 2dB steps). It cannot be used when S.BASS is on.
5 MEMORY button (see page 24)
Press to memorize a station for recall using the STATION (+/�) buttons.
Set up Operation
# TREBLE (+/�) buttons
Use to increase/decrease treble (within a range of �6dB to 6dB in 2dB steps).
6 MPX MODE button (see page 23)
lf the TUNED or STEREO indicators don't light when tuning to an FM station because the signal is weak, press the MPX button to switch the receiver into mono reception mode. This should improve the sound quality and allow you to enjoy the broadcast.
$ Function buttons
Use to select a source for playback or recording.
% S.BASS button
Use to switch on and off the bass boost. Use for a more powerful bass sound. Negates use of BASS buttons.
7 Display (see page 18) 8 Remote sensor
Receives the signals from the remote control.
^ DIRECT button
Use to switch DIRECT playback on or off. This mode bypasses the tone controls and channel levels for the most accurate reproduction of a program source.
9 DSP MODE button (see page 22)
Use to switch between the various DSP modes available (HALL, JAZZ, DANCE, THEATER1, THEATER2) and DSP off. Use to create different surround sound effects from any stereo source.
