PIONEER VSX-D812-K/FXJI
Instrukcja Obsługi

Controlling the rest of your system

10

3 Use the number buttons to enter the preset code. You can find the preset codes on page 64 (VSX-D712) and page 65 (VSX-D812/912). The LED blinks again after you enter the code. If the correct code has been input the power of the component being input will turn on or off. The power of the component being input will only turn on or off if that component is able to be turned on directly by remote control. � You can only input a code for the component type written on each MULTI CONTROL button (except RECEIVER and TUNER). � Even if you don�t input a preset code for the TV (TV/SAT MULTI CONTROL button) you will be able to control your TV using the dedicated TV CONTROL on the remote if you have assigned it to the TV CONT button. � You may not be able to use a particular code even if it is listed on page 64. � The remote control buttons will not be able operate other equipment unless preset with the method above. 4 Repeat steps 2 through 3 to try a different code, or to enter a code for another component you want to control. 5 When you�re done, press RECEIVER.

nent (for example , , or other operation buttons). This can also be used to program additional operations (buttons not covered in the presets) after assigning a preset code. 1 While pressing the RECEIVER button, press and hold the 2 button. The LED blinks. 2 Press the MULTI CONTROL button for the component you want to control. The LED lights. � To exit or cancel press RECEIVER. 3 Point the two remote controls towards each other about 2�5 cm apart then press the button that will be doing the learning on this receiver�s remote control. The LED blinks rapidly.
2 � 5 cm

4 Press the corresponding button on the other remote control that is sending (teaching) the signal to this receiver�s remote control. If the operation has been learned successfully, the LED on this receiver�s remote will blink once then light steadily. If for some reason the operation hasn�t been learned the LED will blink for three seconds and then light steadily. If this happens, keep pressing the (teaching) button as you vary the distance between the two remotes, until you see the the LED light steadily. If there is not enough memory for this button to be learned by the remote, the LED will blink twice and the operation will be canceled. 5 To program additional signals for the current component repeat steps 3 and 4. To program operations for another component exit and repeat steps 1 through 5.

English Italiano Français Deutsch Nederlands Español

Programming signals from other remote controls
VSX-D812/D912 only If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another compo-

59
En