|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Connecting the VX810
About Impedance Before you hook up your speaker cabinet, be sure that you understand a little about impedance. Impedance is the electronic load that the speaker puts on the power amplifier and is measured in Ohms. Here is the tricky, yet simple rule of impedance: When two speakers are wired in "Parallel" the total impedance is cut in half and when two speakers are wire in �Series� the total impedance is the sum of the speakers individual impedance.
Hartke Systems
Distributed Exclusively by Samson Technologies Corp. Hicksville, New York 11802
EFFECT
MODEL 2000 200 WATTS 8 = 120 WATTS 4 = 200 WATTS
CAUTION TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE. SERIAL NUMBER ASSEMBLED IN R.O.K.
~ AC INPUT 115V/230V 50/60Hz FUSE 5A/250V, 180W (115V) 2.5A/250V, 450W (230V)
RETUIRN
SEND
SPEAKER OUTPUTS
HPF OFF ON
8 8
The VX810 impedance is 4 Ohms. So, when two VX810�s are connected together in parallel, the total impedance is 2 Ohms. The impedance of your speaker also has an effect on your amplifier. In general, the lower the impedance, the more power your amplifier will put out.
4
115
CAUTION: THIS IS A 4 OHM CABINET. CHECK THE MINIMUM IMPEDANCE OF YOUR AMPLIFIER BEFORE CONNECTING A SECOND SPEAKER. DAMAGE TO YOUR AMPLIFIER CAN OCCUR IF IMPEDANCE IS TOO LOW.
IMPORTANT: There is a minimum safe impedance so be sure to check the manufacturer�s recommended impedance for your amplifier to avoid any damage to your amplifier or voiding your warranty. Connecting the VX810 to Your Amplifier The VX810 connections are made via 1/4� phone jack located on the rear panel jack-plate. Be sure to make your connection with un-shielded speaker cable. Connect the Amplifier Output to the speaker Input on the VX810�s rear jackplate.
|
|
|
> |
|
