Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 28 (kliknij aby zobaczyć)
Control
Knobs:
The knobs on the control panel can be removed with the controls in the OFF position. Pull each knob straight from the shaft. Wash knobs in warm soapy water or dishwasher; do not use abrasive cleansers or materials. To replace each knob, match flat part of knob opening with the spring on the shaft, returning in OFF position.
Oven
Thermostat
Knob
Adjustment
The oven thermostat knob can be adjusted if the oven temperature is too low or too high and the length of time to cook ALL foods is too long or too short. Do NOT adjust the thermostat knob if only one or two items are not baking properly. To adjust the thermostat knob: _Triangle f _---"_ J __y o_'_Jr_ _ _ _ _L _ _ _O_CHEO_ _ "_._ _____ _ "_' ,--//_"_'Skirt /}\l FIG. 1 _....-_TopScrew \\ o Turn the oven thermostat knob to OFF. Remove the knob and turn it to the underat the top. (See Fig. 1) Loosen the two screws the top screw by the skirt the place, slightly. Holding rotating in knob move one notch, as noted by one click, in direction necessary. If notch indentation is not apparent, tighten screws until clicking is heard. There are so notches neath side. Hold it five that the triangle is in each direction. One notch equals approximately IO° F. EXAMPLE: If the oven temperature is too cool and ALL foods are to cook, the knob should be rotated to move the top screw toward the word "HOTTER". (See Fig. 2) Tighten therequiring a longer time holding screws while tightly period knob to skirt. To replace knob, match flat part of knob opening with spring on the shaft, returning to OFF position. i !.!(_).! _} FIG. 2
IMPORTANT: The oven thermostat knob should be adjusted one notch and then the oven should be tested. (We recommend baking 2 -- 9" yellow layer cakes using a purchased box mix.) If the oven temperature is still too low or too high, repeat the procedure described above. If the knob is rotated too far or in the wrong direction, rotate the knob in the opposite direction until the center of the screw is directly under the triangle, which is the starting point. Initiate the procedure again until the desired temperature is reached.
