Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 2 (kliknij aby zobaczyć)
2182/2189/2289-2
ALARM MODE
Alarm on indicator Mode indicator
You can set three independent alarms. Use the Alarm Mode to turn the alarm and the Hourly Time Signal on and off. � When an alarm is turned on, an alarm tone sounds for 20 seconds when the preset time reached. � When the Hourly Time Signal is turned on, the watch beeps every hour on the hour.
To set the alarm time
Hour Minutes Alarm number
1. Press C while in the Alarm Mode to select Alarm 1 through Alarm 3. Press C.
Alarm 1
Hourly time signal on indicator
Alarm 2
Alarm 3
Hourly Time Signal
2. After you select an alarm, hold down A until the hour digits start to flash on the display. The hour digits flash because they are selected. At this time the Alarm is automatically switched on. 3. Press B to change the selection in the following sequence. Press B.
Hour
Minutes
4. Press C to increase the selected digits. Holding down C changes them at high speed. � The format (12-hour and 24-hour) of the alarm time matches the format you select for normal timekeeping. � When setting the alarm time using the 12-hour format, take care to set the time correctly as morning or afternoon. 5. After you set the alarm time, press A to return to the Alarm Mode.
To stop the alarm
Press any button to stop the alarm after it starts to sound.
To switch an alarm and Hourly Time Signal on and off
1. In the Alarm Mode, press C to select an alarm or the Hourly Time Signal. 2. When the alarm or Hourly Time Signal you want is selected, press D to switch it on and off. � If any alarm is on, the Alarm On indicator is shown on the display when you change to another mode.
Alarm on indicator Hourly time signal on indicator
To test the alarm
Hold down B in any mode (except when a setting screen is on the display) to sound the alarm. Note that this operation also changes the mode.
