Draining Residual Water
Before emptying the residual water, switch the appliance off and unplug it from the mains socket. B. If there is no residual water drain hose in the base of your appliance, open the filter cover. Do this with the aid of the coloured insert from the detergent container. Place a container beneath it. Open the filter but do not withdraw it completely. Turn the filter slowly anticlockwise until water flows out. Wait until all the water has drained off. Now unscrew the filter completely and remove it. Tilt the appliance forwards carefully to allow the water to flow out. Insert the filter with the guide pin upwards and screw it in clockwise to the stop (horizontal handle). Fold the cover up and lock it.
(Proceed to point A or B depending on the model)
A. The residual water drain hose is located in the base of the appliance. 1. Remove the plinth cover. The thin side of the coloured insert from the detergent drawer can be used for this. 2. Grasp the cap and pull out together with the hose. Place a low tub or container beneath it. Pull off cap from end of hose. 3. Drain the water into a low container until no more water flows out. Then close the residual water drain hose and insert it again. Before using the washing machine again: 1. Pour approx. 1 litre of water into the detergent drawer to reactivate the Eco system. 2. Reinsert the plug in the socket.
1.
2. 3. 4.
5.
6.
Before restarting the washing machine: 1. Pour about 1 litre of water into the detergent drawer to reactivate the Eco system. 2. Reinsert the plug in the socket.
