BAUKNECHT WAT 5340
Skrócona Instrukcja Obsługi

GB
CONSUMPTION DATA Programme Temperature Selector (°C) Load (kg) 5 60 60 40 60 40 30 40 5 5 5 2,0 2,0 1,5 1,0 Water (l) 63* 55 55 55 57 49 70 70 Energy (kWh) 1,8 1,15 1,15 0,6 0,8 0,4 0,65 0,55 Programme Duration (min) 120 115 115 95 90 75 55 45

Cotton Cotton + Eco Cotton Cotton Synthetic Synthetic Delicate Wool

Rinse Hold button � � � The laundry remains in the last rinse water without progressing to the spin cycle to avoid creasing and prevent colours from changing. � This option is particularly recommended for the programme Synthetic � � or Delicate � �. � This function is particularly useful if you want to postpone spinning to a later time or when you do not wish to spin the clothes. Note: The programme selector knob stops on the position � �.

Terminate the Rinse Hold option: � Press the �Rinse Hold� button again; the programme will terminate automatically with the spin cycle for the present wash programme. � If you do not wish to spin the clothes, switch off the appliance, turn the programme knob to the drain � � programme and switch on the appliance again. Spin Speed Reduction button � � � Press the button to set the spin speed. Note: Every programme has an automatic maximum spin speed. PROGRAMME START Open the tap and press the On/Off button � �. The pilot lamp lights up. DOOR LOCK During the running programme the door can be opened for adding further laundry. The door locks automatically in all spinning cycles. If the programme is stopped or the electrical power supply is terminated, the door lock will open after approximately 1 minute. Note: If you open the door during the delicate or wool programme, there will be no spinning at the end of the cycle but only draining. If you want to spin the laundry start the gentle spin programme. PROGRAMME END � 1. 2. 3. 4. 5. 1. 2. 3. The programme selector knob is at Press the On/Off button � �. Cancel the special options by pressing the appropriate buttons. Turn the water supply tap off. Wait for the door to unlock (about 1 minute). Open the door and the drum flaps and unload the machine. Press the On/Off button � � to switch off the appliance.

Prewash cycle increases programme duration by approx. 15 min. The data under the heading �Energy� refer to programme �Cotton 60° C� with special option �Eco� selected. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

ADDING DETERGENT AND ADDITIVES Add the detergent and the additives into the dispenser as follows: � Programme with pre-and main wash � Main wash programme without prewash � Fabric softeners and conditioners � Chlorine bleach � Stain remover agents � Anti-scale agents (water hardness 4) Important: � Be careful not to fill more than the �MAX� level mark. � For programme with pre-wash: do not use liquid detergents. � For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry. CLOSE THE DOOR AND SELECT THE PROGRAMME 1. Turn the programme selector knob clockwise to the desired programme. 2. Turn the temperature knob to the required temperature. PRESS ANY DESIRED OPTION BUTTON(S) Eco button � � � The wash time is extended and the water temperature is reduced. � This function saves about 30% in energy without compromising the excellent results of the wash. Intensive Rinse button � � � The water level increases for improved rinsing efficiency. � This option is particularly suitable for areas with very soft water washing baby linen and helps people with allergies.

�

�.

SELECTING A NEW PROGRAMME, OPTIONS AFTER PROGRAMME START Select the new programme, temperature, and option. Press the On/Off button � � to switch on the appliance.

TO STOP, RESET A PROGRAMME BEFORE THE END. 1. Press the On/Off button � � to switch off the appliance. 2. Set the programme selector to Drain � � 3. Press the On/Off button � � to start the drain programme. Only open the door when the programme selector is at � � and the door is unlocked (after approximately 1 minute).

5019 100 12563