Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 2 (kliknij aby zobaczyć)
Presetting Radio Stations
You can preset up to 40 stations (7 for TV, 4 for WB, 24 for FM and 5 for AM ).
Playing the preset radio stations
1 Press TV, WB (Weather), FM or AM. 2 Press PRESET +/�.
Specifications
� Frequency range TV: 2 - 13 ch FM: 87.5 - 108 MHz WB (Weather): 1 - 7 ch AM: 530 - 1 710 kHz Battery life (approximate hours) (JEITA*) Sony alkaline LR6 (SG)** Sony R6P (SR) Tape playback Radio reception 32 40 9 14
Presetting Automatically Scanned Stations
1 Press TV, WB (Weather), FM or AM. 2 Press ENTER for more than 3 seconds. Preset number 1 will flash in the display and the Walkman starts scanning the stations from the lower frequencies and stops for about 3 seconds when a station is received. 3 If you wish to preset the received station, press ENTER while the preset number is flashing. The received station is preset on preset number 1 and the unit starts scanning for the next receivable station. 4 Repeat Step 3 until all receivable stations are preset. To stop scanning
Press RADIO OFF. The radio is turned off at the same time.
Notes � If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed. � If stations cannot be preset automatically, preset stations manually.
Precautions
On batteries
� Do not carry dry batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the batteries are accidentally contacted by a metallic object. � When you are not going to use your Walkman for a long time, remove the batteries to prevent damage from battery leakage and corrosion.
� Power requirements 3V DC batteries AA (R6) x 2 � Dimensions (w/h/d) Approx. 91.2 x 114.8 x 35.5 mm (3 5�8 � 4 5�8 � 1 7�16 inches) excl. projecting parts and controls � Mass FX482ST/FX481: Approx. 150 g (5.3 oz) (main unit only) FX281: Approx. 145 g (5.2 oz) (main unit only) � Supplied accessories Stereo headphones or Stereo earphones (1) Carrying case with belt clip(1) Design and specifications are subject to change without notice.
* Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries Association). (Using a Sony HF series cassette tape) **When using Sony LR6(SG) �STAMINA� alkaline dry batteries (produced in Japan).
On handling
� Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain, mechanical shock, or in a car with its windows closed. � Do not use cassettes longer than 90 minutes except for long continuous playback. � The LCD display may become hard to see or slow down when using the unit at high temperatures (above 40°C/104°F) or at low temperatures (below 0°C/32°F). At room temperature, the display will return to its normal operating condition. � If the unit has not been used for a long time, set it in the playback mode to warm it up for a few minutes before you start using again.
Note � The battery life may be shorter depending on the operating condition, the surrounding temperature and battery type.
If you have any questions about this product, you may call: Sony Direct Response Center 1-(800)-222-7669 or write to: Sony Direct Response Center 12451 Gateway Blvd. Fort Myers, FL 33913
This warranty is valid only in the United States.
On headphones/earphones
Road safety
Do not use headphones/earphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your headphones/earphones at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations.
Declaration of Conformity
Trade Name: SONY Model No.: WM-FX481/FX281 Responsible Party: Sony Electronics Inc. 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone No.: 201-930-6972 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Address:
Preventing hearing damage
Do not use headphones/earphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use.
Presetting Stations Manually
1 Press TV, WB (Weather), FM or AM. 2 Press ENTER. The frequency digits and a preset number flash in the display. 3 While the frequency digits and the preset number are flashing, tune in to a station you wish to store using TUNING +/�, and select a preset number using PRESET +/�. 4 While the frequency digits and the preset number are flashing, press ENTER.
Notes � If you cannot complete step 3 or 4 while the indications are flashing, repeat from step 2. � If a station is already stored, the new station replaces the old one.
Caring for others
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to the people around you.
On maintenance
� To clean the tape head and path, use the cleaning cassette CHK-1W/C-1KW (not supplied) every 10 hours of use. Use only the recommended cleaning cassette. � To clean the exterior, use a soft cloth slightly moistened in water. Do not use alcohol, benzine or thinner. � Clean the headphones/earphones plugs periodically.
Troubleshooting
The display shows incorrect information.
� The batteries are weak. Replace the batteries with new ones.
To cancel the stored station
Follow the procedure above and in step 3, press and hold TUNING +/� until �- - - -� is displayed and select the preset number you want to cancel using PRESET +/�. Press ENTER while �- - - -� is flashing.
The display and the operation are not normal.
� Remove the batteries for 30 seconds or more, and then insert them again. If this does not solve the problem, remove the batteries and leave the unit without batteries for 30 minutes or more, and then insert them again. In this case, preset the stations again, since the preset stations are erased from the memory.
