PHILIPS WP3893/01
Instrukcja Obsługi

8

Insert the tube with the rubber ring in the UV chamber. D Note: Make sure you put the rubber ring and quartz tube in the correct position. To reattach the UV lamp unit, follow steps 6 to 8 in section �Replacing the UV lamp unit�. Close the cover of the UV chamber.
3

9 0 1

Turn the filter cap (1) and remove it (2).

7.0.4 Replacing the filter

D Note: Switch off the pure water dispenser before you replace the filter. The filter has a capacity of up to 3000 litres. When 200 litres have passed through the filter, the filter indicator c starts flashing to indicate that you need to replace the filter. At this point, the appliance can still dispense another 300 litres of water, giving you time to arrange a new filter. The filter indicator keeps flashing until 3000 litres have passed through the filter. Then the filter indicator lights up red continuously and the pure water dispenser does not dispense water until you replace the filter. D Note: We advise you to change the filter every 6 months, even though you might not have consumed 3000 litres. Filter life is subject to the actual level of impurities in your water supply. The filter may therefore expire before 3000 litres without any warning period. 1 Switch off the pure water dispenser. 2 Open the appliance door (1). Pull the filter towards you with the lever (2) and slightly tilt the filter.

4

Grab the handle on top of the filter (1) and slowly pull the filter out of the holder (2).

6

Align the arrow on the cap with the arrow on the filter housing and press the cap down firmly (1). Turn the cap clockwise to fix it (2).

1

EN glis h

5

Put a new filter in the filter holder.