MITSUBISHI WSA55
Instrukcja Serwisowa

MODELS: VS-A50 / WS-A48 / WS-A55 / WS-A65

SERVICING THE DIAMONDSHIELD� 1. DiamondShield� Removal Procedure
The location of the DiamondShieldTM molding clips may vary between models, top and bottom, or sides. Use the appropriate disassembly procedure given below. Note: Wear gloves when handling the DiamondShield� to prevent finger prints.

Top & Bottom Molding Clips

Side Molding Clips

1. Gently insert a small screwdriver between the DiamondShield� and one end of the clip to pry the clip loose.

1. Gently insert a small screwdriver between the DiamondShield� and one end of the clip to pry the clip loose.

2. Remove both clips by pulling them toward you.

2. Remove both clips by pulling them toward you.

3. Carefully insert a small screwdriver into the gap at the top/center point of the Shield and pull the Shield slightly away from the unit. Place your hands at the points shown and gently bow the Shield toward you and remove from the unit. Then re-install the two clips.

3. Carefully insert a small screwdriver into the gap at the side/center point of the Shield and pull the Shield slightly away from the unit. Place your hands at the points shown and gently bow the Shield toward you and remove from the unit. Then re-install the two clips.

2. DiamondShield� Installation Procedure
*(See the Parts List for DiamondShield� part numbers) To install the DiamondShieldTM, reverse the above Removal Procedure.

Page 15