jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 21 (kliknij aby zobaczyć)
See the adjustment location from on page 23 for the adjustment.
TUNER SECTION
0 dB = 1 µV
TAPE SECTION
0 dB = 0.775 V
Cautions during repair When the tuner unit is defective, replace it by a new one because its internal block is difficult to repair. Note on Adjustment The adjustments of tuner section, should be performed according to the following sequence. 1. FM Auto Scan/Stop Level Adjustment 2. FM Stereo Separation Adjustment 3. AM Auto Scan/Stop Level Adjustment FM Auto Scan/Stop Level Adjustment Setting : SOURCE button : FM FREQUENCY SELECT switch : FM 200k
FM RF signal generator antenna terminal 0.01 µF set
Tape Speed Adjustment Procedure : 1. Put the set into the FWD PB mode.
test tape WS-48A (3 kHz, 0 dB)
frequency counter 10 k� set AUDIO OUT REAR
Specification : Constant speed Frequency counter 3,010 to 3,030 Hz Adjustment Location : Capstan motor internal volume (See page 23) DOLBY Level Adjustment Setting : Preset 3 (SHUF/;) button : Light down mark ; (DOLBY OFF)
test tape P-4-D400 (400 Hz, 0 dB)
Procedure : 1. Set to the test mode. 2. Push the SOURCE button and set to FM. Display
set main board TP-L TP-R
SHUF1
Procedure : 1. Put the set into the FWD PB mode. 2. Adjust RV100 (L-CH) and RV200 (R-CH) on main board so that level meter reading is � 6 ± 0.5 dB (0.37 to 0.41 V). Adjustment Location : See page 23.
3. Push the preset 3 button. Display
PRESET
SHUF1
4. Adjust with the volume RV2 on TU1 so that the �FM� indication turns to �2� indication on the display window. But, in case of already indicated �2�, turn the RV2 so that put out light �2� indication and adjustment. Display
PRESET
