Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 117 (kliknij aby zobaczyć)
User Maintenance
Resetting the Lamp Time
The reset lamp time operation you need to perform depends on when you replace the lamp. It is time to replace the lamp. Use the procedure in the User�s Guide to replace the lamp as soon as possible. If you replace the lamp when the above message appears, use the procedure under �To reset the lamp time� on page 117. The lamp has exceeded its service life! The projector will not turn on until you replace the lamp. If you replace the lamp after the above message appears, use the procedure under �To reset the lamp time after exceeding the lamp life� on page 118.
To reset the lamp time
1. Use the procedure under �To
on the projector.
turn on the projector� on page 41 to turn
There is no need to connect a computer or video device to the projector if you plan only to reset the lamp time.
2. Press 3. Press
the [MENU] key to display the setup menu.
the [ ] key to select �Operational Info�, and then press the [ENTER] key.
On the sub-menu that appears, select �Reset Lamp Time�.
4. Press
the [ENTER] key.
This causes the message �Reset lamp time?� to appear.
