C ongratulations, and thank you for your purchase of the Digitech XP-100. The XP-100 offers not one,
not two, but numerous effects in one compact heavy duty pedal chassis design. With the XP-100, you get classic Wah effects, Pitch shifting, Whammy effects, along with a Volume controller and a Chromatic tuner. To keep things quiet, the XP-100 even comes equipped with an adjustable Noise gate. This owner�s guide is provided to get you up and going with the XP-100 and use it to its full potential.
Front and Rear Panel Controls and Functions
1 2 3 6
7
8
9
10
11
12
4
5
1.
2. 3.
Signal LED - Indicates that signal is entering the XP-100. Clip LED - Indicates that signal is clipping in the XP-100. Status Display - The Status Display window shows the current information including: bypass, current effect program number, and Chromatic Tuner information. When the XP-100 is in Program mode (Factory or User), the display will either read: 01-29 (Factory) or U1-U6 (User). *Note- A complete listing of all Factory programs is located on the bottom panel of the XP-100.
4.
Program UP/(Hold)DOWN Switch - Lets you select programs. Pressing once will move up through the program menu. Press and hold and the XP-100 will move down through the program menu. BYPASS/(Hold)TUNER Switch - Puts the unit into Bypass by pressing the footswitch once. To select the Tuner, press and hold the footswitch until the display reads: tu, indicating that you are in Tuner mode. Expression Pedal - Controls the selected effect or volume. Input Level Control - Sets the amount of signal being sent into the unit. The ideal setting for the input control of the XP-100 is to set the input level at a point where the Clip LED indicator occassionally lights.
5.
6. 7.
8. Input Jack - Connect instrument here using 1/4� guitar cord. 9. Effect Output - The Effect output sends only the effected signal out. 10. Dry Output - The Dry output of the XP-100 sends only the un-efffected signal out. 11. Mode/(Hold)Program-Gate Calibration - This button is used to put the XP-100 in and out of User
