AIWA XPV7260
Instrukcja Obsługi

ENGLISH
This operating instructions shows you how to use the supplied remote control.

A

PRECAUTIONS
� Avoid installing the remote control where it may be subject to high temperatures such as from direct sunlight or hot air from the heater, etc. � Strong ambient light sources such as fluorescent lamp or direct sunlight may cause unreliable operation. � Point the remote control at the remote sensor on the main unit.

Before use
Pull out the plastic sheet b from the remote control a as shown. � A

When to replace the batteries

B
1

The maximum operational distance between the remote control and the remote sensor on the front of the player should be approximately 4 meters. When this distance decreases, replace the batteries with the new ones.

INSERTING THE BATTERY � B
1 Insert the tip of a pointed object A into the hole B and pull out the battery holder. a Remote control (back) b Lithium battery (CR2025) c Battery holder 2 Install a lithium battery (CR2025) with the ) side facing up in the battery holder. 3 Push the battery holder into the unit until it clicks.

2

CAUTION
� Keep the lithium battery out of the reach of children. If swallowed, consult a doctor immediately. � To prevent a short circuit, never pinch the battery with pliers, etc. � If the remote control is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage.

3

NAMES AND FUNCTIONS OF PARTS � C
The buttons with no explanations function the same as those of the main unit with identical indications, refer to the instruction manual of the main unit. 1 0-9,+10 � To select track directly Example: To select the 25th track, press +10, +10 and 5. To select the 10th track, Press +10 and 0. The selected track starts to play and continues to the end of the disc. � To select the desired track during program mode Instead of steps 2 and 3 of the PROGRAM PLAY as mentioned in the operating instructions of the main unit, press the numbered buttons and +10 button to select and program a track at the same time. 2 RANDOM/REPEAT It functions the same as that of PLAY MODE on the main unit. 3 REMAIN/ENTER It functions the same as that of DISPLAY/ENTER on the main unit. 4 r,t 5e 6 sPOWER OFF

C

1

Note

2 3

4 5 6

� During off mode, the remote control unit cannot be operated except e which can turned on the unit only when using with AC adapter. � sPOWER OFF cannot be used to start charging or force charging. � During programmed play, the numbered buttons and +10 button cannot be used to select the track directly. � When the HOLD switch of the main unit is set to HOLD position, this remote control unit can still be activated.