JVC XT-TD77R
Instrukcja Obsługi

English

Before the Timer Starts
o o o Check that tape direction is correct. This is important especially when Reverse Mode is off. Set Reverse Mode on if you want to record on both sides of the tape. The VOLUME control is automatically set to 0 when ONCE REC Timer is recording.

It is very easy, and can be very disappointing, to forget to put in a tape, or to accidentally leave a tape in Tape Tray you don�t want recorded over. Although this happens to almost everyone at one time or another, we hope it won�t happen to you! To Change the Recording Timer Setting
To change the settings for the ONCE REC Timer, repeat the setting procedure from the beginning.

Turning the ONCE REC Timer On and Off ���������
1
MENU

Once the ONCE REC Timer has been used to record a source, the setting is maintained but the Timer is set to OFF.

To Turn the REC Timer Off Before the Timer Starts. 1. Press the MENU button.
2 �DAILY� appears on the display and the DAILY indicator in the �TIMER� section of the menu display blinks.

2. Press the up or down cursor key (¡ on the display.
3
CANCEL

or

1) until �REC� blinks

�ONCE REC� appears on the display and the REC indicator in the �TIMER� section of the menu display blinks.

3. Press the CANCEL button.
�REC OFF� appears on the display and the REC indicator in the TIMER section of the menus goes out.

1

MENU

To Record at the Same Time Again. 1. Press the MENU button.
�DAILY� appears on the display and the DAILY indicator in the �TIMER� section of the menu display blinks.

2

2 Press the up or down cursor key (¡ on the display.

or

1) until �REC� blinks

�ONCE REC� appears on the display and the REC indicator in the �TIMER� section of the menu display blinks.

3. Press the SET button.
3
SET

4. Press the ENTER button.
4
ENTER

The DAILY indicator in the TIMER section of the menu changes from a blinking display to a steady display. The ON TIME, OFF TIME, and preset channel number are displayed then the display reverts to the previous display, before the Timer was set.

CAUTION: If the System is unplugged, or a power failure occurs, the timer setting will be erased in a few days. If the settings are erased in this way, reset the timer settings.

46