jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
XV-D9000
Removing the audio(rear L/R) board (See Fig.12~13)
*Prior to performing the following procedure, remove the top panel and rear cover. 1.Remove the three screws L attaching the audio(rear L/R) board. 2.Remove the four screws M attaching the audio(rear L/R) board from back of the body. 3.Disconnect the card wire from CN761 and connector from CN751 on the audio(rear L/R) board. 4.Disconnect the connector from CN697 on the audio power board. CN751 CN761 CN697 Audio-analog (rear L/R)board Fig.12 M
L
Removing the audio(front L/R) board (See Fig.14)
*Prior to performing the following procedure, remove the top panel and rear cover. 1.Remove the audio(rear L/R) board(upper step). 2.Remove the two screws N of the pillar which supports audio(rear L/R) board(upper step). 3.Remove the two screws O attaching the audio(front L/R)board(lower step). 4.Disconnect the connector from CN721 and CN722 on the audio signal(front) output terminal. 5.Disconnect the connector from CN695 and CN696 on the DVD audio power board. 6.Disconnect the connector from CN741 on the signal processing board. Signal processing board CN741