|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
XV-FA92SL
<Loading base assembly unit>
Prior to performing the following procedures, remove the top cover, the front panel assembly, the main tray assembly, the loading base assembly.
Slide gear
Elevator base Shafts
Q
Removing the elevator base (See Fig.18 and 19)
REFERENCE: It is not necessary to remove the traverse mechanism assembly from the elevator base. As the removing procedure of the traverse mechanism, please refer to �Removing the traverse mechanism assembly�. 1. Turn over the loading base assembly and remove the two screws Q. 2. Remove the elevator base upward.
Slide gear
Fig.18
Reattaching the elevator base
REFERENCE: From above the loading base, turn the load base counterclockwise until the slide gear stops at the back end as shown in Fig.19. 1. Reattach the elevator base to the loading base assembly while fitting the two shafts on the side of the elevator base to the grooves of the slide gear. 2. Reattach the two screws Q.
Load base
Fig.19
1-11
|
