JVC XVM565BK
Instrukcja Serwisowa

XV-M565BK/M567GD
Removing the cams R1/R2 assembly and cam gear L (See Fig.23)
Slit washer 1. Remove the slit washer fixing the cams R1 and R2 assembly. 2. By removing the two pawls s fixing the cam R1, separate R2 from R1. 3. Remove the slit washer fixing the cam gear L. 4. Pull out the cam gear L from the C.G. base assembly. Cam gear L Slit washer Cam R2

L
Pawl s Pawl s Cam R1

Removing the C.G. base assembly (See Fig.23 and 24)
Remove the three screws L retaining the C.G. base assembly. [Caution] To reassemble the cylinder gear, etc.with the cam unit (cam gear and cams R1/R2 assembly), gear unit and drive unit, align the position of the pawl n on the drive unit to that of the notch on the cam gear L. Then, make sure that the gear unit is engaged by turning the cam gear L (See Fig. 24).

Cam switch board C.G. base assembly

Fig.23
Cam gear L Cam R1, R2 assembly

Notch

Pawl

n

Gear unit

Cylinder gear

Drive unit

Gear bracket

Fig.24

1-17