JVC XVN45LIMK2
Instrukcja Serwisowa

2.1.5 Removing the rear panel (See Figure 8, Figure 9) � Prior to performing the following procedure, remove the top cover. (1) Remove the six screws E attaching the rear panel. (2) Disconnect the power cord from connector P901 on the power supply board (3) Remove tie band.

Rear panel

E
G G

E
Fig.8

E

CN901 P901

H Tie band Power cord

CN702 Output terminal board
2.1.6 Removing the output terminal board and power supply board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/mechanism assembly/rear panel. (1) Remove the two screws G attaching the output terminal board. (2) Disconnect the card wire from connector CN702 on the output terminal board. (3) Remove the three screws H attaching the power supply board. (4) Disconnect the card wire from connector CN901 on the power supply board.

HH Power supply board Fig.9

1-10 (No.XA003)