Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 18 (kliknij aby zobaczyć)
Getting started
To connect to a TV with the SCART connector
You can enjoy using the unit by simply connecting it to your television set with a 21-pin SCART cable. To hear audio sound with better quality, connect the audio output to your audio equipment.
English
Y/C - COMP switch . SCART cable (not supplied)
CENTER RIGHT LEFT REAR
The unit
SUBWOOFER
VIDEO OUT
VIDEO
AV COMPU LINK
VIDEO OUT AV
PCM / STREAM RIGHT LEFT FRONT OPTICAL COAXIAL S-VIDEO
Y/C
COMP.
TV
IN S-VIDEO VIDEO
LEFT RIGHT
AV
DIGITAL OUT
AUDIO OUT
IN
AUDIO
Set the Y/C - COMP switch correctly according to your TV. . � If the TV only accommodates the composite video signal, set the switch to �COMP.� . � If the TV accommodates the Y/C signals, set the switch to �Y/C� so that you can enjoy better-quality pictures. � If the TV accommodates the RGB signals, set the switch to �COMP , as well as make the unit feed the RGB signals by .� following the procedure shown below.
How to make the unit feed the RGB signals
The unit cannot output the RGB signals from the SCART connector and the S-video (Y/C) signals from the S-VIDEO jack simultaneously. In the initial (factory-preset) condition, the S-VIDEO jack is active, while the RGB signals cannot be output. To make the unit feed the RGB signals, follow the procedure below. Note that the S-VIDEO jack does not feed correct signals when the unit is set to output the RGB signals. ¶ When the unit is turned on
1 Set the Y/C - COMP. switch to �COMP.� . 2 Press and hold down the 7 (STOP) button on the front panel when no disc is inserted or while the unit is stopped.
�S-VIDEO� appears in the display window after a few seconds.
(Display Window)
LPCM MPEG DOLBY DIGITAL DTS
