To connect to an amplifier/receiver equipped with 5.1-channel inputs
The unit supports the linear PCM multichannel format of DVD AUDIO and can feed multichannel audio output signals from the 6 ANALOG AUDIO OUT jacks. It is also equipped with the DTS and Dolby digital decoders. So you can enjoy any type of the high quality surround sounds by connecting the unit to an amplifier/receiver equipped with the 5.1-channel inputs. Connect the unit's ANALOG AUDIO OUT jacks to the analog 5.1-channel inputs of an amplifier or receiver using the supplied audio cables.
Red Red Yellow
English
The unit
SUBWOOFER CENTER RIGHT LEFT REAR VIDEO
AV COMPU LINK
PCM / STREAM RIGHT LEFT FRONT OPTICAL COAXIAL S-VIDEO COMPONENT Y PB PR
DIGITAL OUT
AUDIO OUT
VIDEO OUT
Amplifier or receiver
White White White Red
White
FRONT LEFT
AUDIO IN
Yellow
Red White
REAR
LEFT RIGHT
Audio cable (supplied)
Red White
CENTER
SUBWOOFER
Audio cable (supplied)
Red
� Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units. NOTE
� When using the 5.1-channel outputs of the unit, set the �DOWN MIX� in the �PREFERENCE 2� on-screen display to �OFF� and select �5.1 CHANNEL� or �EXPERT� in the �SPK.SETTING� on-screen display. If the �EXPERT� is selected, you can control the audio output balance of the speakers (see pages 57 and 59).