|
|
|
Kto jest w sklepie?
Sklep przegląda 5710 gości i
2 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
16
MAlETENAN( ;E
acid or sugaryspilloversas they may discolorthe porcelain, Use the correct size cooking utensil to avoid boilovers, Neverplace cookwareor aluminumfoil directly onthe oven bottom, To remove: bottomagainst excessivespilloversespecially Protectoven When cool, loosen the two screws located along the front of the oven bottom. Slidethe screws backto releasethe frontof the oven bottom.Grasp oven bottom, lift up and pull forward until rear tabs release. Then, remove oven bottomfrom oven.
proper baking,your range must be level. Leveling legs are located on each corner at the base of the range. Level by turningfloors are not level. For range from accidently tipping, _ Some the legs. To prevent _)Y range should be secured to the floor by sliding a rea_ leveling legintothe anti-tip bracketsuppliedwith the range
i
c_ c9_
To replace: Insertthe tabs into the slots on the back oven wall. Lowerinto place.Slidetwo screwsforwardand tighten, Be sure bottom isfitted intoslotsand screwsare tight.Ifnot correctly replaced,oven bottom may become warped and cooking results will be affected,
servicing: 1. Shut-off gas supply to appliance. 2. Disconnectelectrical supply to appliance, if equipped. 3. Disconnectgas supply tubing to appliance. 4. Slide range forwardto disengagerange from the anti-ti Followthese proceduresto removeapplianceforcleaningo bracket. (See Installation Instructions for location ( bracket.) 5. Reverse procedure to reinstall. If gas line has bee disconnected, checkfor gas leaks after reconnection.J qualified servicer should disconnect and reconnect th, gas supply.(SeeInstallation Instructionsfor gas leakte_ method.) To prevent range from accidently tipping, range must b, securedto the floor byslidingrear levelingleg intoananti-til bracket supplied with the range. WARNING: Possible risks may result from abnorma i usage,includingexcessive loadingofthe ovendoorando the risk of tip over,shouldthe appliance not be reinstallec accordingto the installation instructions.
To remove: When broileris cool, remove broiler insertand pan. Open drawer halfway and pull metal clip located in center of drawer bottomupward as far as it will go (about2 inches).The drawercan now bepulled allthe way out of the compartment,
TOreplace:Slidegroovesattop ofdrawer ontoguiderailsat sides of broiler compartmentand push drawerin to close.
|
|
|
> |
|
