PROGRESS Z1600
Instrukcja Obsługi

Note: On model Z1670 (fitted with remote suction control) the suction power can be adjusted by sliding the knob on the hose handle. The cleaner will not operate if the hose is not fitted.

Model Z1670

Upholstery nozzle The upholstery nozzle can be used for cleaning upholstered furniture or curtains.

EMPTYING THE DUST CONTAINER
When finished cleaning, switch off the cleaner before rewinding the electrical cord. Unplug the cleaner from the wall socket and press the cord rewind pedal. Hold the plug with one hand and guide the electrical cord with the other hand to prevent it from striking you or the cleaner. Note: The dust container should be emptied after each vacuum cleaning, or as necessary, and when filter indicator lights up and stays on. 1. To remove the dust container, unlock it by pressing the two buttons situated on either side of the handle and pull it out. 2. Press the orange locking lever on the dust container to open the lid. To prevent dust escaping from the dust container, place the dust container inside a plastic bag before opening the lid. 3. Clean the dust container, close the lid ensuring that the orange locking lever clicks into position. 4. Replace the dust container by pushing it down lightly until the locking catch clicks into position.

SELECTING ACCESSORIES
Combination floor nozzle The combination floor nozzle can be set for hard floors or carpets. Press the foot operated toggle lever on the floor nozzle to select the desired setting. When the floor nozzle is set for hard floors, the bristles will extend beyond the base of the floor nozzle. When the floor nozzle is set for carpets, the bristles will be retracted. Combination upholstery and brush nozzle This nozzle can be used for upholstery or brushing. To clean upholstery, open the two flaps on the nozzle and attach it with the bristle side facing the extension tube. To use the brush side of the nozzle, close the two flaps and attach the nozzle to the extension tube. Combination crevice nozzle and dusting brush This nozzle can be used as a crevice nozzle or as a dusting brush. To select the desired setting rotate the end of the nozzle to change from crevice nozzle to dusting brush. The crevice nozzle can be used for cleaning crevices, corners, between cushions or difficult to reach places. The dusting brush can be used to clean furniture, books, lamp shades and shelves.

Push

CLEANING OR REPLACING THE FILTERS
Caution: Before doing any type of cleaning or maintenance to the cleaner, always ensure that the cleaner is unplugged from the wall socket. Damaged filters must be replaced immediately. Do not operate the cleaner with damaged or clogged filters. Do not clean the filters in a washing machine and do not use a hair dryer to dry the filters. Do not use cleaning agents or hard bristled brushes as they may damage the delicate filter surfaces. Dust container filters Note: There are two filters in the dust container. A HEPA filter and a fine mesh cage filter. These two filters must be cleaned regularly. Check and if necessary clean or replace these filters each time that the dust container is emptied or when the filter indicator lights up and stays on.
7

6