ELECTROLUX Z5634
Instrukcja Obsługi

English
CLEANING THE HOSE AND NOZZLE. BATTERY REPLACEMENT

1

2

3

4

The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked or if the overheat indicator starts blinking (picture 1). In such cases, disconnect from the mains and allow to cool for 30 minutes. Clear blockage and/or replace filter(s) and restart. 2 Use a cleaning strip or similar to clean the tubes and hose. 3 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose.

Note! The warranty does not cover any damage to hoses caused by cleaning them.
4 To avoid deterioration of the carpet/hard floor nozzle, clean it as often as possible. The easiest way to clean it is by using the hose handle. Cleaning the power nozzle 5 Disconnect from the mains and remove entangled threads, etc. by snipping them away with scissors. 6 Use a screwdriver to remove the nozzle cover. 7 Remove the brush cylinder and bearings, then clean as necessary. 8 To clean the wheels, gently lever them from their mountings and clean as necessary. 9 Replace the cover and make sure it is securely fastened. Cleaning the turbo nozzle 10 Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. by snipping them away with scissors. Use the hose handle to clean the nozzle. Battery replacement 11 When flat, replace the batteries in the remote control handle, as shown in the picture. We recommend use of alkaline batteries.

5

6

7

8

Note! Do not throw away the batteries with household waste. Discard of them in special recycling containers and heed local regulations.

9

10

11

86