INSTALLATION
It is mandatory that all operations required for the installation be carried out by QUALIFIED PERSONNEL in accordance with existing rules and regulations. The appliance must be installed in accordance with " X " specification (EN60.335-2.6). The cooker must not be installed higher than the worktop. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Before your appliance is connected to the mains electricity supply, check to ensure that the voltage and the frequency shown on the rating plate corresponds with your supply voltage. This appliance must be earthed. Before installation ensure that the local distribution conditions (gas type and pressure) and the presetting of the appliance are consistent. This appliance must not connected to a chimney. It has to be installed and connected in accordance with the rules in force. Special attention should be paid to the applicable disposal concerning ventilation. The adjusting conditions of this appliance are mentioned on the rating plate. Connection to gas supply. Check that the gas flow and the diameter of the supply pipe is sufficient to supply all the appliances of the installation. � Check that all connections are tight. � Install an accessible and visible gas tap to isolate the appliance.
LOCATION
The cooker has been registered as a �Class X�appliance according to Fire Risk Regulations. Any adjacent cabinets or walls must not exceed the cooker�s height. The cooker may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom or shower room. The minimum distance combustible material can be fitted above the cooker in line with the edges of the cooker is 69 cm (see fig.) It is mandatory to keep 2cm distance to the adjacent furniture. The appliance must be set on a heatproof floor. The adjustable feet must not be removed.
69cm
62 cm
69cm
15 cm
2 cm
2 cm
2 cm
2 cm
Levelling
The appliance is provided with adjustable small feet placed in the back and front corners of the base. By adjusting the small feet it is possible to change the height of the appliance so as to ensure a better levelling with other surfaces and an even distribution of the liquids contained in pots and pans.
