Changing the opening direction of doors and Panelling
If you refrigerator has top panel (fig. 4), you can manage in the same way from point 1 to point 6 and then: 7... Unscrew the axle of the upper hing (9 Fig. 4) and replace it at the opposite side (10 Fig. 4). 8... Remove the little lid put on the opposite side of the central hinge and use it to cover the new holes left where the hinge was placed. For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
Fig. 4
How to panel the doors:
1... Remove one of the side strips.
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows:
2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm.
