Changing the opening direction of doors and Panelling
If you wish to change the opening side of the doors proceed as follows: 1... Remove the handles of the doors, if they are side fixing by screws. 2... Take off the plinth pressed on to. 3... Remove the inferior hing taking care for the downer door not to fall off and not to lose the plastic spacer. With a 10mm spanner unscrew the the hinge pin and reassemble it on the opposite side. 4... Lift the downer door off the central hinge. 5... Remove the central hinge taking care for the upper door not to fall off. 6�Take the upper door off the upper hinge. 7�Unscrew the plastic bolts of the opposite side of the place of the central hinge taken out and introduce them in the holes occupied before fy the hinge. 8�Unscrew the axe of the upper hinge and screw it to the hinge on the opposite side. Place upper door. Assemble the lower hinge reinforcement in the opposite side it was situated. For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
How to panel the door:
1... Remove one of the side strips.
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows:
2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm.
