AEG ZD684
Instrukcja Obsługi

Fixing to the adjacent units
To prevent the dishwasher tilting, it must be secured to either the worktop or adjacent kitchen cabinet/wall using the brackets supplied. Insert the two fixing brackets into the slots provided in the top front part of the dishwasher as shown in the figure. Secure the brackets to the adjacent units with the 3.5 x 16 screws using the upper or the side holes. The appliance must be secured to the underside of the worktop using the brackets provided. Failure to do this could cause damage or injury.
II54

Attention! The sides of the dishwasher must never be drilled to prevent damage to hydraulic components.

Kitchen plinth adjustment
To allow correct opening of the door it is sometimes necessary to cut the kitchen plinth. Refer to the cutting table. According to dimensions (a) and (b) as shown on the figure, you will find on the following table the depth (x) of the cut to be made on the plinth. The dimensions (a) and (b) of the table are those most frequently used in the kitchen furnitures.

II59

Height (a)*
170 160 150 140 130 120 110 100 90
II15

a b

40 136 131 125 118 110 100 93 85 75 50 135 131 125 118 110 102 92 85 75 60 137 132 125 118 110 102 94 85 75

Depth (b)*

70 138 134 128 120 110 104 95 85 75 80 90 100 / / /

X

139 130 124 115 105 98 88 78
/ /

138 129 120 110 100 90 80
/

135 125 115 105 95 85
600 mm minimum

(*) dimensions in mm

X Dimensions of the cut on the plinth
25
INS48en