Fitting the furniture door to the appliance Furniture door measurements: Height= Width= Depth= 1225 mm (Min.) 596 mm 20 mm (Max.)
Position the runners (E) at the top and bottom of the inside of the kitchen unit as shown in Fig. 7 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. Fig. 7
Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 9
E
20mm
PR35
Inner door reversal
D285
Open both the appliance door and that of the kitchen unit to approx. 90°. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8
8mm
Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. 10) and withdraw it from its seat together with the door; remove plug (2) and �t it in the hole left open on the opposite side; turn the door through 180°, remove the bracket (1) and re�t it on the opposite side. Re�t the door and insert the top pin and bottom bracket (1), pushing it into place. Fig. 10
180°
PR34
2 1
PR140
To ensure correct storage of food, the door is �tted with a simple spring device which holds it in the open position until it is properly closed.
