Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. The dishwasher is fitted with a number of alarm systems which can help you to quickly determine the cause of any problems such as the dishwasher will not start or stops during operation, all push buttons are inoperative except for the On/Off push button or the indicator light of the programme underway and one or more of the phase indicator lights (washing, drying, end of programme) are flashing. Press the On/off push button to switch off the dishwasher and carry out the following suggested corrective actions listed below. Once the checks have been carried out switch on the dishwasher and start a washing programme, if the fault code reappears, contact your local Service Force Centre.
Symptom
The machine will not start
Fault code
Solution
q q q
The door has not been properly closed. The plug is not properly inserted in the power socket. There is a power failure. Ensure the water tap is open. Ensure the mains water supply has not been cut off. The inlet hose may be squashed or bent. Reposition the hose. The inlet hose may be blocked. Switch off the water supply and clean the filter. The drain hose may be squashed or bent. Reposition the hose. The sink may be blocked. Clear any blockages. The drain hose extension is not correct. Follow the instructions for connecting to the waste. There is no vent in the end of the drain hose. Close the water tap and contact the Service Force Centre.
The machine does not fill with water
Washing phase indicator light flashing
q q q q
The dishwasher will not drain
Drying phase indicator light flashes
q q q q
Protection against flooding is active General
Drying and washing indicator lights are flashing One or more phase indicator lights are flashing
q
q
Switch off the dishwasher. Switch it back on and start the programme. If the alarm reappears, call the local Service Force Centre. Dishes are rattling against each other, refer to �Loading your machine�. The spray arms are knocking against the dishes. Refer to "Loading your machine". The dishwasher is not level, or not properly built-in. Check that there is salt and that the salt cap is tight. Check that the right level of the water softener is set. The rinse aid has run out or too little is being used. The baskets are too full. The dishes have not been arranged properly. The spray arms do not rotate The spray arms are clogged. The filters are clogged. The filters are not in the correct position. Not enough detergent has been used or it is unsuitable. The detergent is old or has gone hard. The salt container cap is not properly closed. The washing programme selected is too gentle.
The machine is noisy
q q
The door is difficult to close Visible lime deposits or white film on the dishes The dishes are not quite dry The dishes are not clean (poor wash)
q q q q q q q q q q q q q q
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door
Mod. ........
