ZANUSSI ZENB2925SI
Instrukcja Obsługi

MAINTENANCE AND CLEANING
Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply.

SOMETHING NOT WORKING
Before contacting your local Service Force Centre, check the following points: Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee.

Changing the light bulb
If it becomes necessary to replace the lamp, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow.

Internal cleaning
Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG ODOUR.

Symptom
No power to the appliance

Solution
Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown.

The light does not come on

Ensure that the bulb is correctly fitted. Replace the bulb if it has blown.

External cleaning
Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. You MUST ensure that the appliance is switched OFF. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure.

Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Service Force Centre). Replace the light cover by sliding it into its original position.

Check the door light switch is not jammed. The temperature in the fridge or freezer section is too high Check the termostat control knob on the top panel is turned to the correct setting relative to ambient conditions. Check the ambient temperature is within the appliance�s operating limits, please refer to the installation section in this instruction book. Relocate the appliance if necessary. The freezer door will not open The compressor runs continously Has door just been opened? If so leave for a few minutes to allow the air pressure to equalise. Adjust the thermostat control knob to give correct temperature control. See �Setting the temperature�. Check that the doors are closed. Large quantities of food have recently been placed in the cabinet and/or door is frequently opened. Check that air vents is not obstructed. Noise Refer to normal operating sounds.

Automatic Defrosting
Your appliance has been designed to be frost free. This means there is no need to defrost your appliance as this will be carried out automatically.

PR259

If, after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls.

When the appliance is not in use
When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells.

10

11