ZANUSSI ZGF7899CX
Instrukcja Obsługi

Fitting the Hob to the Worktop
Carry out the building in of the hob as follows: � put the seals supplied with the hob, on the edges of the cut out: place them at 8 mm from the front and rear edge and at 50 mm from the side edges, as shown in figure 4, taking care that the seals meet without overlapping; � place the hob in the cut out, taking care that it is centred; � fix the hob with the relevant fixing clamps and screws, as shown in figure 5. When the screws have been tightened, the excess seal can be removed. The edge of the hob forms a double seal which prevents the ingress of liquids.
Fig. 4

Seal

a

FO 0199

Fig. 5

10