Fig. 5 Dimensions are given in millimeters These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 5. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 150 mm. Hanging forniture units or hoods must be placed at 650 mm minimum from the hob. Fig. 6
.
4 0 8
5 5 m i n
560 150 min
FO 2038
Fitting the hob to the worktop
The hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 6. Before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge (Fig. 7) of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. To install the hob, proceed as follows: 1) Remove the pan supports, the burners caps and crowns and turn the hob upside down, taking care the ignition candles are not damaged in this operation. 2) Place the sealing gasket all around the glass top edge as shown in diagram 7. 3) Fit the hob in the cut out and push it down until the glass top and the working top make contact, as shown in diagram 8.
