ZANUSSI ZHN6001N
Instrukcja Obsługi

Part 1 - INSTALLATION INSTRUCTIONS

1 - GENERAL INFORMATION
This cooker hood is designed to be fitted into the bottom of a cabinet positioned over a cooking area. It must be connected to a central ducting system outside the house. Before starting the installation, consideration should be given to the difficulties to be found during installation. The installation work must be undertaken by a qualified and competent person in conformity to the rules concerning the evacuation of contaminated air. The manufacturer disclaims all liability for any damage or injury caused as a result of not following the instructions for installation contained in the following text.

2 - SAFETY WARNINGS
2.1- When used in the extraction mode, the cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric, such as a central heating flue or water heating flue. 2.2- Before connecting to the mains supply ensure that the mains voltage corresponds with the voltage on the rating plate inside the hood. 2.3- Connect the cooker hood to the mains via a bipolar switch which has 3mm clearance between the contacts. 2.4- The appliance must be earthed. 2.5- When installed, the hood must be positioned at least 65cm above the hotplate. 2.6- Never do flambé cooking under this cooker hood. 2.7- Never leave frying pans unattended during use as overheated fat and oil may catch fire. 2.8- Before carrying out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 2.9- If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood.

3 - INSTALLATION
3.1 - Installation under a hanging unit
Using the template provided, drill the four holes required to fix the hood into the underside of the hanging unit, and drill the central hole for the ducting pipe. Fix the hood using the four 4.2x44.4 mm screws provided, screwing them in from the inside of the overhead unit.

3.2 - Wall installation
Using the template provided, mark the points on the wall that must be drilled to fix the hood. Drill using an � 8 mm bit and insert the rawl plugs. Screw two 4.2x44.4 mm screws 8 GB

�

�

�

�

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

� �

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�

�