Changing the opening direction of doors and Panelling
If you wish to change the opening side of the doors proceed as follows: 1... Remove the handles of the doors. 2... Take off the plinth pressed onto cabinet. 3... Remove the lower hinge taking care for the lower door not to fall off. Using a 10mm spanner, unscrew the hinge pin and reassemble it on the opposite side. 4... Lift the lower door off the central hinge. 5... Remove the central hinge taking care for the upper door not to fall off and not to lose the plastic washer. 6... Take the upper door off the upper hinge. Be carefull not to lose the plastic washer. 7... Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge. 8... Unscrew the axle of the upper hing and screw it into the hinge on the opposite side. Make sure to fit in the metal washer for blocking. 9... Place upper door. For the remaining parts proceed the other way round. Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.
How to panel the door:
If your appliance is provided with metal strips for panelling and you wish to do so proceed as follows: 1... Remove one of the side strips. 2... Loosen the screws of the remaining strips. 3... Start putting on the panel where you took off the strip pushing it right up to the end. 4... Replace the strip on this side. 5... Tighten all screws NOTE: The panel dimensions must be 2 mm. shorter than the doors. Maximun thickness of the panel is 4 mm. 18
