Location
This appliance is designed to be built-in to a space having the dimensions given in Fig. 2. Fig. 2
820 870
Door reversibility
Remove the two screws which �x the upper hinge to the door. Carefully lean the appliance on its back and remove the plastic insert (Fig. 4). Fig. 4
600
547 550
820-870
596
D506
100-170
The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 3). Fig. 3
D447
D507
Remove the two screws which �x the lower hinge to the door. Remove the four screws which �x the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that �x the upper hinge to the appliance and remove the hinge itself. Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 5), and, using the screws removed from the lower part, �x it to the base of the appliance itself. Remove and re�t the other hinge on the upper part of the appliance on the opposite side. Fix the two front screws into the upper and lower hinges (Fig. 5). Fig. 5
D510
Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and �t the insert supplied with the appliance on the opposite side.
