Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
USE
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. � � � � room temperature; how often the door is opened; the quantity of food stored; location of appliance.
TECHNICAL INFORMATION
Net Fridge Capacity lt. Net Freezer Capacity lt. Energy Consumption kWh/24h Energy Consumption kWh/year Freezing Capacity 24h Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Rising time 186 44 1,049 383 3 19
A medium setting is generally the most suitable.
Operation
Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. To stop operation, simply turn the thermostat knob to position «O»
Dimensions mm High Width Depth 1400 550 600
Fresh food refrigeration
To obtain the best performance: � � � do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. The technical infomation are situated in the rating plate on the internal left side of the appliance .
Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on:
INSTALLATION
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A). Ideally, however, the appliance should not be positioned below overhanging wall units (B). Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet.
Movable shelves
The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
A
B
10 100 mm
NP004
D040
Attention It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
