Shelf holders
Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Move the shelf holders in the direction of the arrow, raise the shelf from the rear and push it forward until it is freed and remove the retainers.
B A
Rejillas movibles
En las paredes del compartimento existen unas guÃas que consienten poner las rejillas a distintas alturas.
D040
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E.E.C. Directives: - 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
Compartimiento para botellas
Almacene las botellas con el cuello hacia adelante. Atención: Coloque echadas sólo las botellas sin abrir. Para guardar botellas ya abiertas puede usted alzar el compartimiento hasta dejarlo inclinado. Para ello tire del compartimiento hacia adelante hasta que sea posible virarlo hacia arriba e introduzca entonces la superficie delantera en el nivel inmediato superior.
Ubicación estantes de la contrapuerta
Para poder colocar confecciones de varios tamaños es posible colocar los estantes de la contrapuerta a varias alturas. La operación se efectúa de la siguiente manera: Empujar gradualmente el estante en el sentido indicado por las flechas hasta llegar a desengancharlo, luego volverlo a montar en la posición deseada.
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted as shown in the figure . Slacken the screws and insert the spacer under the screw head, then re-tighten the screws.
