This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A.
820 min 195
120
Building-in
The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. B) supplied with the appliance.
35 � 12.5-14 depth 16-2 2
600
600
5
15
59
6
5
70 min.
818
416 176,5
22+1,5
541 8
59
160
5-59
8
P0422S
C
165
90 490
P0965
A
c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.
Preparation and assembly of the door
The machine is originally pre-arranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in the hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. B).
d) Counter-magnet (6)
6 4
1 1
2
7
5
The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the countermagnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D).
416 B
3 23
P0982
8
B
6 4
a) Door
The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base.
8
C
D
b) Hinges
To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 12.5-14 mm depending on the depth of door furniture) on the inner side of the door. The distance between the holes hobs fixing centres must be 416 mm. The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions.
