When the cycle begins, the status of cycle is displayed by the corresponding led.
3.7. Action during a programme
3.7.1. Adding of laundry
Press the Start/Pause pushbutton : the corresponding light flashes as long as the programme is paused. You will then hear a double "click" in the locking device when the cover opens. Press the same pushbutton again to resume the programme. For reasons of safety, you cannot open the cover if the temperature of the washing water is too high.
3.7.2. Modifying the current programme
Before modifying the options of the current programme, you must put the washing machine to pause by pressing on the «Start/Pause» pushbutton. If it is impossible to make the modification, the corresponding light flashes for few seconds. If you decide to change the programme in any case, you will need to cancel the current programme (see below).
3.7.3. Cancelling the programme
If you want to cancel a programme, turn the programme selector knob to the «off» position of the programme selector. You can then select a new programme.
3.8. End of program
The washing machine stops automatically. You will hear a double "click" in the locking device when the cover opens. The cycle end light goes on. If you choose the rinse hold position, the rinse hold light* illuminates to inform you that water has to be drained before you can open the cover. To terminate the cycle, you can then spin the washing by choosing the spin program or drain it by choosing the drain program. Turn the program selector knob to the "Off" position. Take out the laundry. Pull out the power supply plug and close the water supply tap. Note : we recommend that you should leave the cover and the drum open after use to air the washing drum.
