Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 25 (kliknij aby zobaczyć)
Water inlet
Connect the hose to a tap with a 3/4� thread. Do not use previously used hoses for water connection.
�U� piece supplied
P1199
P1088
Place the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring there is an air break between the drain hose and standpipe.
38 mm (11.2�) standpipe diameter
Installation should comply with local water authority and building regulations� requirements. The appliance must be connected to a cold water supply. A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appliance. If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5.02m (16.5 ft) between the appliance�s inlet and the bottom of the water storage tank. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
P1200
When discharging into a standpipe ensure that the top of the standpipe is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level.
3 pin
P1201
P0021
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18mm. If your drain hose looks like this (see below) you do not require the �U� piece�. Just push the hose firmly into the standpipe.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods. 1. Into a drainage standpipe. Firstly form a hook in the end of the drain hose using the �U� piece� supplied.
