ZANUSSI ZWF388
Instrukcja Obsługi

9. Programme selector dial

The selector dial can be turned either clockwise or counter-clockwise. Use this selector dial to select the required programme. At the end of each programme the selector dial must be turned to position �O�, to switch off the machine. ATTENTION! If the programme selector dial is turned to another position (programme) when the machine is working, the lights of the programme progress display start to flash. The machine will not perform the new selected programme, but it will continue running on the same cycle. REMEMBER! In the event a wrong programme has been selected and the machine is already working, proceed as follows: 1. Turn the programme selector dial to position �O�. 2. Select the new required programme. � If the machine has not already gone through the rinse cycle, when you decide to change the running programme, in the new programme the water and the detergent from the previous cycle will be reused, making it an energy-saving tool. On the other hand, if it is already in the rinse phase; detergent, bleach,� must be re-measured. 3. Press INICIO / PAUSA button, to start the new cycle.

36