Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
Pay attention to the level and temperature of the water in the washing machine! When you close the door and press the �On/Off�button again, the washing machine will resume the programme from the point where it had been interrupted.
Note: when you switch the machine on, if you must erase the previously performed programme, it is also sufficient to press the FABRICS button and select a new programme. Press the �On/Off� button to switch the machine off. The relevant light will go out. Remove the laundry from the washing machine. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry. We advise you to close the water supply tap and disconnect the plug from the socket. Leave the door ajar in order to air the washing machine.
13. End of programme
At the end of the programme, the washing machine stops automatically and gives an audible signal. If you had selected the �Rinse Hold option, the light of the �Start/Pause� button goes off, the phase indicator lights �Rinse Hold�and �End� illuminate to indicate that the water must be drained. To complete the cycle, first press �Skip/Reset� button and then choose one of the following options: � Drain only: - Press FABRICS button in order to select the desired programme and press 3 times �Skip/Reset� button until the �Drain� light illuminates. Then depress �Start/Pause� button. � Drain and Spin: - Choose the previously selected programme by means of the FABRICS button, afterwards change the spin speed if needed, by means of the �Spin� button and then press �Skip/Reset� button twice until the �Spin� light goes on and then depress �Start/Pause�button. When the programme has been completed the audible signal is given. Press the �Skip/Reset� button repeatedly to erase the programme that has just been carried out. If you omit to do this, the next time you switch the washing machine on, you will hear the audible signal.
