Programming radio stations
You can store up to a total of 50 radio stations. Automatic programming Press the ® key on the remote control for about 3 seconds. SEARCH is displayed and all the available stations are programmed (overriding all former programmed radio stations).The system will store first the RDS stations with a strong enough signal, then the RDS stations with a weaker signal and finally the non RDS stations. Note: - to stop the automatic installation, press the � key. All stations before the stop, are stored into the memory. Manual programming
& Briefly press the ® key on the remote control.
Give name
& Select the station number of the radio station
control for about 3 seconds.The cursor flashes on the first of 8 characters.
� Press the cursor up/down to change the
character. � Press the OK key to confirm the new name. Note: To erase a station name: - Select the station number you want to erase the name of. - Press and hold the b key for about 3 seconds. - Press and hold the � key for about 3 seconds. - The message DELETED appears and the RDS name or the frequency is displayed.
The current station number starts flashing and the station name, in case of a RDS station, or the tuned frequency is displayed. Hold down the Ã� or â� key to start the search for a new radio station.The search will stop on the next radio station and display the tuned frequency which will eventually be replaced by the detected RDS name. Note: briefly and repeatedly press the Ã� or â� key to fine tune the frequency if necessary. Use the P- or + key or the digit keys to select the station number where you want to store the new radio station. Press the ® key to store the new radio station on the selected station number. Repeat & to â�� to store another radio station. Note: To stop the manually installation, press the â�¡ key. Nothing is stored and everything is restored to the radio status just before entering the manual installation mode.
