SONY ADI-1150D
Instrukcja Serwisowa

3-6. Drum Exit Side Block

4. Remove the Yoke Plate Remove the screw, then remove the yoke plate from the T tension arm. Installation 5. Install the Yoke Plate (1) Install the yoke plate to the T tension arm as shown in the figure, then tighten the screw. (2) Apply locking compound to the screw.
Screw (B2 X 5)

T tension arm

Yoke plate Apply locking compound

White paint

Remove/Install the Yoke Plate

6. Install the T Tension Arm (1) Clean the shaft with a cleaning cloth moistened with cleaning fluid. (2) Insert the bearing into the hole of the T tension arm. (3) Hook the two tension springs to the T tension arm as shown in the figure. (4) Pass the T tension arm through the shaft while putting DME on the TR-79 board into the T tension arm. (5) Fix the T tension arm by the stop washer.

T tension arm

Stop washer Bearing

Springs

Shaft (Cleaning) DME

TR-79 board

Install the T Tension Arm

3-113